Full Wave Charging for Mio 125 MX

Disclaimer: I will not held responsible if something goes wrong upon using this conversion without enough knowledge of how the system works.

This DIY is derived form mastercircuits tutorial. Make sure to have a full wave rectifier like this, for china bikes

1. Remove Front Fairings, Cover Under, Under Fender and Inner Fairings
2. Remove Stock rectifier Located just bellow the Ignition switch ( pictures for reference )

3. Remove tape of the harness near the ignition terminal and look for YELLO/RED wire

4. Cut the yellow wire going up ( for lights ) and add wire 

 5. Tap the YELLOW/RED wire to BROWN WIRE of the IGNITION TERMINAL

6. REMOVE wire from the RECTIFIER TERMINAL/SOCKET

7. INSTALL FW RECTIFIER  red;red gree;black yellow;yellow pink;white black;add wire tap it to the brown wire of ignition terminal

 8. SECURE the WIRES

 9. Find a place where you can fix the new rectifier

 10. Locate wire from the magneto

11. REMOVE YELLOW/RED and BLACK Wires from the SOCKET, PUT the BLACK wire in YELLOW REDs original LOCATION, then FLOAT the YELLOW/RED wire 

12. START UR ENGINE